A: Transfer to a separator a volume of Injection, equivalent to about 50 mg of phenobarbital sodium, add 15 mL of water, add 2 mL of hydrochloric acid, shake, and extract the liberated phenobarbital with four 25-mL portions of chloroform. Filter the combined extracts through a pledget of cotton or other suitable filter into a beaker, and wash the separator and the filter with several small portions of chloroform. Evaporate a 50-mL portion of the chloroform solution of phenobarbital on a steam bath with the aid of a current of air. Add 10 mL of ether, again evaporate, and dry the residue at 105 for 2 hours: the IR absorption spectrum of a potassium bromide dispersion of the residue so obtained exhibits maxima only at the same wavelengths as that of a similar preparation of USP Phenobarbital RS.

B: The retention time of the major peak in the chromatogram of the Assay preparation corresponds to that of the Standard preparation, both relative to the internal standard, as obtained in the Assay.

(Official January 1, 2007)

pH 4.5 Buffer solution, Mobile phase, Internal standard solution, and Chromatographic system— Prepare as directed in the Assay under Phenobarbital.

Standard preparation— Transfer about 15 mg of USP Phenobarbital RS, accurately weighed, to a 50-mL volumetric flask, add 25 mL of Mobile phase, and sonicate if necessary to dissolve. Add 15.0 mL of Internal standard solution, dilute with Mobile phase to volume, and mix to obtain a solution having a known concentration of about 0.3 mg of USP Phenobarbital RS per mL.

Assay preparation— Transfer an accurately measured volume of Injection, equivalent to about 65 mg of phenobarbital sodium, to a 100-mL volumetric flask, dilute with Mobile phase to volume, and mix. Transfer 25.0 mL of this solution to a 50-mL volumetric flask, add 15.0 mL of Internal standard solution, dilute with Mobile phase to volume, and mix.

Procedure— Proceed as directed for Procedure in the Assay under Phenobarbital. Calculate the quantity, in mg, of C12H11N2NaO3 in each mL of the Injection taken by the formula: in which 254.22 and 232.24 are the molecular weights of phenobarbital sodium and phenobarbital, respectively, V is the volume, in mL, of Injection taken, and the other terms are as defined therein.