U.S. PHARMACOPEIA

Search USP29  
Lutein
Click to View Image
C40H56O2 568.87

--carotene-3,3¢-diol (3R, 3¢R, 6¢R) [127-40-2].
» Lutein is the purified fraction obtained from saponification of the oleoresin of Tagetes erecta L. It contains not less than 80.0 percent of total carotenoids calculated as lutein (C40H56O2). It contains not less than 75.0 percent of lutein and not more than 8.0 percent of zeaxanthin, both calculated as lutein (C40H56O2), on the anhydrous basis.
Packaging and storage— Preserve in tight, light-resistant containers. Store in a cold place.
USP Reference standards 11 USP Lutein RS.
Identification—
A: Ultraviolet Absorption 197U
Spectral range: 300 to 700 nm.
Solution— Prepare as directed for the Test solution in the test for Content of total carotenoids.
Ratio: A446 / A474, between 1.09 and 1.11.
B: The retention time for the major peak in the chromatogram of the Test solution corresponds to that in the chromatogram of the Standard solution, as obtained in the test for Content of lutein.
Water, Method I 921: not more than 1.0%.
Residue on ignition 281: not more than 1.0%.
Lead 251: not more than 1 µg per g.
Heavy metals, Method II 231: not more than 5 µg per g.
Zeaxanthin and other related compounds—
Solvent, Mobile phase, Standard solution, Test solution, and Chromatographic system— Proceed as directed under Content of lutein.
Procedure— Inject a volume (about 10 µL) of the Test solution into the chromatograph, record the chromatogram, and measure the peak responses. Calculate the percentage of zeaxanthin in the portion of Lutein taken by the formula:
T(ri / rs),
in which T is the content, in percentage, of total carotenoids as determined in the test for Content of total carotenoids; ri is the individual peak response of zeaxanthin; and rs is the sum of the responses of all the peaks: not more than 8.0% of zeaxanthin is found. Calculate the percentage of other related compounds in the portion of Lutein taken by the formula:
100(ri / rs),
in which ri is the individual peak response of any other peak in the chromatogram (excluding zeaxanthin and lutein); and rs is the sum of the responses of all the peaks: not more than 0.1% of any single other impurity is found.
Organic volatile impurities, Method IV 467: meets the requirements.
Solvent: dimethylformamide or dimethyl sulfoxide.
Content of lutein—
Solvent: a mixture of hexanes, acetone, toluene, and dehydrated alcohol (10:7:7:6).
Mobile phase— Prepare a filtered and degassed mixture of hexane and ethyl acetate (75:25). Make adjustments if necessary (see System Suitability under Chromatography 621).
Standard solution— Dissolve a suitable quantity of USP Lutein RS in Mobile phase to obtain a solution containing about 150 µg per mL.
Test solution— Transfer about 1 mL of Test stock solution from the test for Content of total carotenoids, and evaporate under a stream of nitrogen to dryness. Add 1 mL of Mobile phase, and sonicate to dissolve.
Chromatographic system (see Chromatography 621) The liquid chromatograph is equipped with a 446-nm detector and a 4.6-mm × 25-cm column that contains 3-µm packing L3. The flow rate is about 1.5 mL per minute. Chromatograph the Standard solution, and record the peak responses as directed for Procedure: the relative retention times are about 1.05 for zeaxanthin and 1.0 for lutein; the resolution, R, between lutein and zeaxanthin is not less than 1.0; the tailing factor is not more than 2; and the relative standard deviation for replicate injections is not more than 2.0%.
Procedure— Inject a volume (about 10 µL) of the Test solution into the chromatograph, record the chromatogram, and measure the peak responses. Calculate the percentage of Lutein taken by the formula:
T(ri / rs),
in which T is the content, in percentage, of total carotenoids as determined in the test for Content of total carotenoids; ri is the individual peak response of lutein in the Test solution; and rs is the sum of the responses of all the peaks: not less than 75.0% of lutein is found.
Content of total carotenoids—
Solvent: a mixture of hexanes, acetone, toluene, and dehydrated alcohol (10:7:7:6).
Test stock solution— Transfer about 15 mg of Lutein to a 100-mL volumetric flask, and dissolve in and dilute with Solvent to volume.
Test solution— Quantitatively dilute the Test stock solution (1 in 100) with dehydrated alcohol to obtain a solution having a final concentration of about 1.5 µg per mL.
Procedure— Determine the absorbance of the Test solution at the wavelength of maximum absorbance at about 446 nm, with a suitable spectrophotometer, using dehydrated alcohol as a blank. Calculate the percentage of total carotenoids as lutein (C40H56O2) by the formula:
1000A / 255W,
in which A is the absorbance of the Test solution; W is the weight, in g, of Lutein taken to prepare the Test stock solution; and 255 is the absorptivity of the pure lutein.
Residual solvents 467: meets the requirements.
(Official January 1, 2007)
Auxiliary Information— Staff Liaison : Lawrence Evans, III, Ph.D., Scientist
Expert Committee : (DSN05) Dietary Supplements - Non-Botanicals
USP29–NF24 Page 2353
Pharmacopeial Forum : Volume No. 31(4) Page 1133
Phone Number : 1-301-816-8389