Nitrates and Nitrites Absent
Place about 1 g of the substance, accurately weighed, in a 500-mL Kjeldahl flask of hard borosilicate glass. The material to be tested, if solid or semisolid, may be wrapped in a sheet of nitrogen-free filter paper for convenience in transferring it to the flask. Add 10 g of powdered potassium sulfate or anhydrous sodium sulfate, 500 mg of powdered cupric sulfate, and 20 mL of sulfuric acid. Incline the flask at an angle of about 45
, and gently heat the mixture, keeping the temperature below the boiling point until frothing has ceased. Increase the heat until the acid boils briskly, and continue the heating until the solution has been clear green in color or almost colorless for 30 minutes. Allow to cool, add 150 mL of water, mix the contents of the flask, and again cool. Add cautiously 100 mL of sodium hydroxide solution (2 in 5), in such manner as to cause the solution to flow down the inner side of the flask to form a layer under the acid solution. Immediately add a few pieces of granulated zinc, and without delay connect the flask to a Kjeldahl connecting bulb (trap), previously attached to a condenser, the delivery tube from which dips beneath the surface of 100 mL of boric acid solution (1 in 25) contained in a conical flask or a wide-mouth bottle of about 500-mL capacity. Mix the contents of the Kjeldahl flask by gentle rotation, and distill until about four-fifths of the contents of the flask has distilled over. Titrate with 0.5 N sulfuric acid VS, determining the endpoint potentiometrically. Perform a blank determination, and make any necessary correction. Each mL of 0.5 N sulfuric acid VS is equivalent to 7.003 mg of nitrogen.
When the nitrogen content of the substance is known to be low, the 0.5 N sulfuric acid VS may be replaced by 0.1 N sulfuric acid VS. Each mL of 0.1 N sulfuric acid VS is equivalent to 1.401 mg of nitrogen.
Nitrates and Nitrites Present
Place a quantity of the substance, accurately weighed, corresponding to about 150 mg of nitrogen, in a 500-mL Kjeldahl flask of hard borosilicate glass, and add 25 mL of sulfuric acid in which 1 g of salicylic acid previously has been dissolved. Mix the contents of the flask, and allow the mixture to stand for 30 minutes with frequent shaking. To the mixture add 5 g of powdered sodium thiosulfate, again mix, then add 500 mg of powdered cupric sulfate, and proceed as directed under Nitrates and Nitrites Absent
, beginning with Incline the flask at an angle of about 45
When the nitrogen content of the substance is known to exceed 10%, 500 mg to 1 g of benzoic acid may be added, prior to digestion, to facilitate the decomposition of the substance.